STREAM GAGING INSTRUMENTS

Current Meters
Meter Sensing Instruments
Current Meter Outfits
Handline
Sounding Reels
Wading Rods
Ice Meter Gaging
Boat Equipment
Bridge Board
Cranes
Cable Cars
Cableways & Accessories
Bank-Operated Cableways
Cables & Connectors
Sounding Weights
Tagline
Fluorometric Dye Tracing
Surface Velocity Meters
Acoustic Doppler Meters
Winches & Travellerways

 

 
Suspension Equipment

Ice Meter Gaging Equipment


USGS Ice Rod

 

The Ice Rod is a heavy-duty, 1-inch (2.5 centimeter) diameter, lightweight aluminum rod used for suspending ice meters in fast velocities. The lower section, 32.9 inches (83.6 cm) long, is built to screw into the standard USGS ice meter. The rods are made with stainless steel screwed connections. English unit extensions are 36 inches long, and all sections are calibrated in feet and tenths of feet. Metric unit extensions are 1 meter long, and all sections are calibrated in 5 centimeter increments. No sliding support is used with this rod as the ice meter mounts at the base of the rod and is handheld for various depths of flow. A protective foot attaches at the bottom of the rod as shown in the figure to provide a base to measure depth at the bottom ice thickening and to protect the meter during a measurement. The foot locates the meter bucket wheel centerline at exactly 0.3 foot from the bottom surface. The foot assembly is designed to fit through a standard 8" diameter ice hole.

Item No. DESCRIPTION WEIGHT

105-050

    9 ft. English Ice Rod

8 lbs.

105-052

3m Metric Ice Rod

8 lbs.

TOP

USGS Ice Foot

As described above, this foot can be used with the ice rod and meter for ice thickness measurement, bottom measurement and current meter protection. It is available for both the English and metric rods.     


Click on Pictures to Enlarge

 

Item No. DESCRIPTION WEIGHT

105-055

 English Ice Foot 1 lb.

105-056

Metric Ice Foot 1 lb.

TOP

USGS Ice Meter Tilting Harness - Model 6830

The tilting harness consists of a stainless steel meter plate and linkage assembly that suspends a Type AA - ice meter by sounding cable with either a 30lb. or 50lb. sounding weight. The linkage assembly is designed to allow the weight to tilt so that the meter harness can fit through a standard 8" ice hole. The rear link and strap are different sizes for the 30 lb. and 50 lb. sounding weight harness assembly and must be specified.        

 

Item No. DESCRIPTION WEIGHT

105-058

Harness for 30 lb. Weight

10 lbs.

105-059

Harness for 50 lb. Weight

12 lbs.

105-060

Harness for both 30 lb. and 50 lb.Weight

14 lbs.

TOP

 

 

1700 JOYCE AVENUE  COLUMBUS, OH 43219   U.S. Only: 1-800-561-9677   PHONE: 1-614-297-9877  FAX: 1-614-297-9878  sales@rickly.com

COPYRIGHT ©  1997-2009, RICKLY HYDROLOGICAL COMPANY.  ALL RIGHTS RESERVED