|
|
 
Cable Connectors
& Cable
Ellsworth Cable
 Ellsworth Cable is a stainless
steel reverse lay cable with an insulated center copper conductor.
This allows suspension of the sounding weight and meter assembly,
and provides an electrical circuit between the meter and the
headphone. This cable is available in two sizes: 0.10-inch and
0.125-inch (0.25 cm and 0.32 cm) diameters. This cable can be
provided in any specified length. Information on terminal rings
and hooks and nicropress sleeves for cable end preparation can be
provided when requested.
|
|
107-005 |
.100 in. cable |
|
|
107-006 |
.125 in. cable |
|
|
TOP
The Type B connector is a two-piece, cast
brass unit which clamps over 0.10 or 0.125-inch (0.25 or 0.32 cm) diameter
Ellsworth sounding cable. It is standard equipment for use with B-56 and
E-53 sounding reels, and can be used on A-Pack and A-55 reels. It can be
used for the heaviest sounding weights or sediment samplers.
|
107-001 |
Type B Connector |
0.5 lb. |
TOP
The pressed sleeve connector is used with
0.10-inch (0.25 cm) diameter Ellsworth cable, and is normally used
with A-Pack and A-55 reels. It should not be used with weights
exceeding 75 pounds (34 kg).
|
107-002 |
Pressed Sleeve Connector |
0.5 lb. |
TOP
The surface water repair kit comes in a 12
compartment tool box and includes all the tools and spare parts needed
to make field repairs of sounding reel cable systems. Equipment in the
kit include: cable-cutting tool, nicropress tool, AMP tool, emery
cloth, cable-sleeving, cable sleeves, terminals, parallel connectors
and repair instructions.
|
107-010 |
Surface Water Repair Kit |
12 lbs. |
TOP
The standard USGS connector is a 1/4" single prong
phone plug. This is a very reliable military grade connector. The
two-prong connector is commonly used and can be specified if
required.
|
107-012 |
USGS 1/4" plug |
0.1 lb. |
|
107-014 |
USGS 1/4" socket |
0.1 lb. |
|
107-016 |
Two-prong plug |
0.1 lb. |
|
107-018 |
Two-prong socket |
0.1 lb. |
TOP
|
)
)
)
)
)
