Battery
chargers may be used in data acquisition applications
where AC power is available. The charger is used to keep
the battery charged for continuous operation of the
datalogger or data acquisition system during power outages
and over time without having solar panels or having to
continually swap batteries.
This dual-rate battery charger is a wall mount battery
charger designed for cyclic applications where recharge
time is crucial and the battery may be left on charge
indefinitely. This charger senses battery demands and
automatically switches between the fast charge and float
modes. With no danger of overcharge, the charger is
capable of recharging batteries in less than 16 hours when
in fast charge mode. LED's visually indicate recharge on
this fail-safe charger. Two models are available: 120 VAC
60 hz and 230 VAC 50 hz.
- Wall Mount Plug-in Charging Module
- Overcharge Protection
- Temperature Compensation
- Short Circuit and Reversed Polarity Protection
- 1.5 Amp trickle charge
- Dual voltage automatic
- Nominal 12 V; Range 13.5 to 14.7 V
- Capacity: 2 to 10 AH
901-030
120/60 Wall Mount Charger 2
lbs.
901-035
230/50 Wall Mount Charger 2
lbs.
Gel Cell Battery Charger
This
regulator charger is made especially to trickle charge 12
volt gel cell batteries. It's fully automatic and
precision-engineered for years of dependable use.
3-function LED light keeps you informed of the charger's
operation at a glance.
- 6 amp medium charge rate for most everyday needs -
charges in 6 to 8 hours.
- Fully automatic - will not overcharge batteries.
- 3-function LED lights signal Charging, Charged and
Check Battery.
- Super-grip clamps with side-mount battery feature.
- Heavy-gauge steel case with baked enamel finish.
901-040
Gel Cell Charger 8
lbs.
Deep-Cycle Battery
Chargers
This
heavy-duty regulator charger supports large (26 to 105
amp-hour) 12 volt batteries and small (8 amp-hour) 6 or 12
volt batteries. Automatically switches between fast
charging and trickle charging as needed.
Temperature-compensated, current-limited output properly
charges batteries while allowing no "back current" from
battery. Powered from 110-VAC. These chargers provide
one-unit capability to charge almost any battery including
conventional automotive batteries. Circuit breakers
protect against overloads and reverse hookup. Timer lets
user decide how long to charge.
- 10 amp fast charge for every day charging needs -
charges a deep-cycle battery in 7 to 11 hours; an
automotive battery in 3 to 5 hours.
- 12-hour timer with "hold" position for timed or
continuous charging of deep-cycle batteries.
901-045
Deep Cycle Charger 11 lbs.
Battery Charger/Discharger
The Battery Charger/ Discharger is an intelligent
microcontroller-based, battery charger/discharger tester.
Using a charge-discharge-charge cycle, the condition of
the battery may be fully characterized. The Battery
Charger/Discharger can determine if batteries are capable
of holding their specified charge. When a gel cell battery
is used over a one year period, it often requires charging
and discharging several times before it holds a full
charge. This is a powerful tool for districts that have
multiple stations with lots of batteries.
- 115V or 230V, 50-60 Hz AC only
- 26, 24, 12, 10, 8, 7, 4 Amp hour batteries
- Discharger load-3.75 ohms
- 14.5V charging current up to 5 Amps
901-050
Battery Charger/Discharger
12 lbs.
Top
